5.8 Motors
5.8.1 Replacing the axis-1 motor
Replacing the motor on an inverted manipulator
To replace the motor on an inverted manipulator, the axis-1 gearbox must be
drained and a special lifting accessory must be used, according to the procedures
in this section.
The alternative is to lift down the manipulator to floor-standing, see Lifting down
the manipulator from inverted to floor-standing position on page 195.
Location of the motor
The motor is located as shown in the figure.
xx2000000241
Summary of the replacement procedure
This list is a brief summary of the replacement procedure, containing the major
actions to be performed.
1 If installed in an inverted position (option 3317-1): drain the axis-1 gearbox.
2 Replace the motor.
Continues on next page
Product manual - IRB 5720 319
3HAC079195-001 Revision: A
© Copyright 2022 ABB. All rights reserved.
5 Repair
5.8.1 Replacing the axis-1 motor
To Next Page
Loading...
