ABB OmniCore C90XT - Installing the Scalable I;O Devices

3.7.2 Installing the scalable I/O devices
Location
The location of the base unit used as a scalable I/O internal unit is shown in the
following illustration.
xx1900001467
The base unit can also be used as a scalable I/O external unit, with or without
add-on devices.
For more information about installing, configuring, and using the scalable I/O units,
see Application manual - Scalable I/O.
Required parts
NoteArticle numberPart
DSQC10303HAC058663-001Local I/O Digital base [3032-1]
3HAC060919-001Connectors digital base/add on
DSQC10313HAC058664-001Digital add-on [3033-2]
DSQC10323HAC058665-001Analog add-on [3034-2]
3HAC060925-001Connectors I/O Analog
DSQC10333HAC058666-001Relay add-on [3035-2]
3HAC060926-001Connectors I/O Relay
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 417.
-Standard toolkit
-ESD protective wrist band
Continues on next page
110 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.7.2 Installing the scalable I/O devices