ABB OmniCore C90XT - Cleaning of the Controller Cabinet

4.3.2 Cleaning of the controller cabinet
Required equipment
NoteEquipment, etc.
ESD protectedVacuum cleaner
Cleaning considerations
This section specifies some special considerations when cleaning the controller.
• Always use ESD protection.
• Always use cleaning equipment as specified above. Any other cleaning
equipment may shorten the life of paint work, rust inhibitors, signs, or labels.
• Always make sure that all protective covers are fitted to the controller before
cleaning.
• Never remove any covers or other protective devices when cleaning the
outside of the controller.
• Never use compressed air or spray with a high pressure cleaner.
• Never leave the door open when cleaning the exterior.
Product manual - OmniCore C90XT 159
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
4 Maintenance
4.3.2 Cleaning of the controller cabinet