3.3.2 Unpacking
Unpacking the controller
Action
Make a visual inspection of the packaging and make sure that nothing is damaged.1
Remove the packaging.2
Check for any visible transport damage.
Note
Stop unpacking and contact ABB if transport damage is found.
3
Clean the unit with a lint-free cloth, if necessary.4
Make sure that the lifting accessory used (if applicable) is suitable to handle the weight
of the controller.
5
If the controller is not installed directly, it must be stored as described in Transportation
and storage conditions on page 39.
6
Make sure that the expected operating environment of the controller conforms to the
specifications as described in Operating conditions on page 40.
7
The controller can be taken to its installation site as described in section On-site in-
stallation on page 56.
8
54 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.3.2 Unpacking
To Next Page
Loading...
