3.4.2 Mounting the FlexPendant holder
Note
To avoid dropping the FlexPendant from height, the holder should be placed in
a comfortable working height.
Always use and store the FlexPendant in such a way that the cable does not
become a tripping hazard.
When not using the device, place it so it does not accidentally fall.
Required equipment
NoteSpare part numberEquipment
See Standard toolkit for con-
troller on page 417.
Standard toolkit
3HAC064927-001FlexPendant Holder w/t E-
stop cover
Note
The FlexPendant should always be placed in the holder when it is not used and
it is not allowed to use by unauthorized person.
Mounting the FlexPendant holder onto a flat surface (Horizontally)
Use this procedure to mount the FlexPendant holder onto a flat surface, like the
top of the controller, desktop and so on.
Note/illustrationAction
Clean the surface and make sure it is dry.1
xx2000002352
Remove the protective liner from the
tape.
2
Continues on next page
58 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.4.2 Mounting the FlexPendant holder
To Next Page
Loading...
