3.5.5 Connecting power supply to and grounding the controller
Note
How to manufacture a cable with connector is described in section Fitting the
connector on page 70.
DANGER
A residual current device (RCD) must be installed.
Location of power supply connection
xx1900001479
Location of grounding point
Note
The whole cabinet ground is connected to the X0.PE point.
Continues on next page
Product manual - OmniCore C90XT 73
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.5.5 Connecting power supply to and grounding the controller
To Next Page
Loading...
