3.7.8 Installing the cable grommet assembly
Location
The illustration shows the location of the cable grommet assembly on the controller.
xx1900001480
Note
The end user need to buy proper grommets according to the diameter of the
cables which need to go through the grommet.
This will affect the protection level of the cabinet if it's not executed correctly.
It is recommended to use icotek KT grommet.
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore C90XT via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
3HAC066396-001Cable grommet asm
Continues on next page
Product manual - OmniCore C90XT 137
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.7.8 Installing the cable grommet assembly
To Next Page
Loading...
