Overview of this manual
About this manual
This manual contains instructions for:
• mechanical and electrical installation of the controller
• maintenance of the controller
• mechanical and electrical repair of the controller
Usage
This manual should be used during:
• installation and commissioning, from lifting the product to its work site and
securing it to the foundation, to making it ready for operation
• maintenance work
• repair work
• decommissioning work
Note
It is the responsibility of the integrator to conduct a hazard and risk analysis of
the final application and to ensure its safety.
It is the responsibility of the integrator to provide safety and user guides for the
robot system.
Who should read this manual?
This manual is intended for:
• installation personnel
• maintenance personnel
• repair personnel.
Prerequisites
A maintenance/repair/installation craftsman working with an ABB robot must:
• be trained by ABB and have the required knowledge of mechanical and
electrical installation/repair/maintenance work.
• be trained to respond to emergencies or abnormal situations.
References
Document IDDocument name
3HAC065034-001Product specification - OmniCore C line
3HAC065464-009Circuit diagram - OmniCore C90XT
3HAC032104-001Operating manual - RobotStudio
3HAC065036-001Operating manual - OmniCore
3HAC065037-001Operating manual - Integrator's guide OmniCore
3HAC065041-001Technical reference manual - System parameters
Continues on next page
Product manual - OmniCore C90XT 9
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
Overview of this manual
To Next Page
Loading...
Need help?
General
