3.4 On-site installation
3.4.1 Required installation space
Dimensions
The following illustration shows the required installation space for the OmniCore
C90XT controller.
xx1900001448
• A free space of 500 mm on the front of the controller is required if the
controller is mounted on a desk (not rack-mounted).
• A free space of 200 mm on the back of the controller is required if the
controller is mounted on a desk (not rack-mounted).
• A free space of 500 mm on the left side of the controller is required if the
controller is mounted on a desk (not rack-mounted). Do not place any cables
over the left cover as it leads to inefficient cooling.
• A free space of 520 mm on the right sides of the controller is required if the
controller is mounted on a desk (not rack-mounted). Do not place any cables
over the right covers as it leads to inefficient cooling.
The following illustration shows the dimensions between the feet of the OmniCore
C90XT controller, as seen from below.
Continues on next page
56 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.4.1 Required installation space
To Next Page
Loading...
