ABB OmniCore C90XT - 3.3 Transporting and handling

3.3 Transporting and handling
3.3.1 Lifting the controller cabinet
Lifting device
Use the four lifting eyes (Torque: 11.3 Nm-12.6 Nm) or a fork lift when lifting the
controller, as shown below.
The following figure shows the maximum angle between the lifting straps when
lifting the controller. The weight of the controller module is detailed in section
Weight on page 39.
°
06
xx1900001445
Note
After removing the lifting lock, tighten the plastic screws (Torque: 0.8 Nm-1 Nm)
for the controller cabinet.
Product manual - OmniCore C90XT 53
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.3.1 Lifting the controller cabinet