Removing the slot cover (baseline)
Note/IllustrationAction
xx1900002444
Remove the attachment screws.1
Take out the cover from the inside of the
controller.
2
Refitting the cable grommet assembly
Refitting the cables to the cable grommet assembly
Note/IllustrationAction
xx1900002337
Insert and equip the cable to the corres-
ponding KT grommet.
1
Continues on next page
Product manual - OmniCore C90XT 139
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.7.8 Installing the cable grommet assembly
Continued
To Next Page
Loading...
