Note/IllustrationAction
xx1900002333
Route the cables through the cut-out.5
Screws: Torx pan head screw M4x8 (4 pcs)Refit the cable entry frame to the enclos-
ure wall and secure with the screws.
6
Tightening torque: 1.5 Nm.
xx1900002332
Refitting the cable grommet assembly
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Continues on next page
Product manual - OmniCore C90XT 141
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.7.8 Installing the cable grommet assembly
Continued
To Next Page
Loading...
