ABB OmniCore C90XT - Page 204

Disconnecting the antenna
Note/IllustrationAction
xx1900001948
Disconnect the antenna cable from the
Connected Services Gateway by rotating
the connector.
1
Record the cable routine when you re-
move the cable from the cabinet.
2
Removing the cable grommet assembly on
page 313.
Take the cable out from the cable grom-
met.
3
xx1900001949
Remove the magnet part of the antenna
from the top the cabinet.
4
Removing the Connected Services Gateway
Note/IllustrationAction
Disconnect:
• K7.X1 - K2.X3
i
• K7.X2 - A2.X5
Note
The connector K7.X2 is locked;
grab the connector, push it in to
release it and then remove the
connector.
1
Continues on next page
204 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.2.6 Replacing the Connected Services Gateway
Continued