Note/IllustrationAction
xx1900001888
Hook up the Ethernet extension switch
to the bracket and then push the switch
into position.
Note
During the installation, there should be
no gap between the upper surface of the
Ethernet extension switch and the lower
surface of highest bracket on the main
computer.
xx1800000972
3
xx1800000491
Refitting the robot signal exchange proxy
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Continues on next page
Product manual - OmniCore C90XT 237
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.2.8 Replacing the main computer
Continued
To Next Page
Loading...
