Note/IllustrationAction
xx1900001900
Fasten the DC-bus cable with a new
cable tie to the drive unit.
4
xx1900002338
Fasten the EtherCAT cable with a new
cable tie to the drive unit.
5
Reconnect:
• T4.X7, T4.X8, T4.X9
• T4.X5 - A1.X4
• T4.X3 - A1.X12
• T4.X1 - A1.X5
6
Refitting the power supply
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Continues on next page
Product manual - OmniCore C90XT 263
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.2.11 Replacing the drive unit
Continued
To Next Page
Loading...
