Note/IllustrationAction
Connect the adapter cable to the convey-
or tracking module.
• B1.X1 - K2.X19.1 & K2.X19.2
• B1.X7 - K4.X1-5
Stick the other connector onto the side
of the digital base with the self-adhesive
part.
4
Concluding procedure
Note/IllustrationAction
Closing the door on page 174.Close the door.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 165.
2
Product manual - OmniCore C90XT 283
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.2.13 Replacing the conveyor tracking module(CTM)
Continued
To Next Page
Loading...
