ABB OmniCore C90XT - Page 314

Removing the cable grommet assembly
Note/IllustrationAction
Remove the cables out from the clips in
the cabinet carefully.
Note
Make records about the sequence that
cables are removed. The cables need to
be installed in the same position.
1
xx1900002340
Remove the attachment screws on the
cover.
2
Push the cable grommet assembly into
the cabinet.
3
Take the cable grommet assembly out.4
Releasing the cables from the cable grommet assembly
Note/IllustrationAction
xx1900002332
Unscrew the cable entry frame from the
enclosure wall.
1
Continues on next page
314 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.3.6 Replacing the cable grommet assembly
Continued