ABB OmniCore C90XT - Page 334

Note/IllustrationAction
Screws: Torx, countersunk screw M4x10 (4
pcs)
Secure it with the attachment screws.4
xx1900001924
Connect:
• X24 - A2.X3
5
Secure the harness ETH outlet with
cables with the clips on the cabinet.
Tip
Use the same position as from removing
the harness ETH outlet with cable.
6
xx1900001922
Refit the cover plate.7
Continues on next page
334 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.3.8 Replacing the harness ETH outlet with cable
Continued