NoteArticle numberEquipment
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC065464-009Circuit diagram - OmniCore C90XT
Removing the power cable and power cable cover
Note/IllustrationAction
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
1
Disconnect the FlexPendant from the
controller.
2
xx1800001189
Remove the attachment screws for the
power cable cover.
3
xx1800001190
Remove the power cable cover.4
Continues on next page
Product manual - OmniCore C90XT 343
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.4.1 Replacing the power cable and power cable cover
Continued
To Next Page
Loading...
