SignificanceDescription
Three (3) LEDs indicating the Wi-Fi or 3G signal level.
• ON: The unit is connected to the network and working ok.
• OFF: Problem with connector, antenna, or sim card.
RF, signal
strength status
LEDs
Required test equipment
Equipment needed for troubleshooting:
NoteEquipment
Multimeter
Insulating gloves
Preparations
Action
Check the FlexPendant for errors and warnings.1
Power the controller off. Wait one minute, power the controller on.2
Make sure that the control system power supply is in run-time mode.3
Wait 30-60 seconds after power-on.
Continues on next page
390 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
7 Troubleshooting
7.3.6 Troubleshooting the Connected Services Gateway
Continued
To Next Page
Loading...
