Note/illustrationAction
xx2000002355
Hang the holder with the bracket to the
desired place.
2
Hanging the front part of the FlexPendant holder with screws (Vertically)
Use this procedure to hang the front part of the FlexPendant holder to the desired
place.
Note/illustrationAction
xx2000002356
Remove the four screws.1
Separate the rear part from the FlexPend-
ant holder.
2
Clean the surface and make sure it is dry.3
Continues on next page
60 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.4.2 Mounting the FlexPendant holder
Continued
To Next Page
Loading...
