12 Modify the selected point (Point 1) by tapping the Modify Position function
key.
xx2100000377
13 Move the conveyor belt forward a distance where the reference point still
can be reached by the robot.
Long and equally spaced distances between the four calibration points (Point
1-4) are preferred since this increases the accuracy of the calibration.
14 Repeat the steps 10-13 for the points Point 2, Point 3, and Point 4.
Continues on next page
204 Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.3.4.4 Defining the base frame (OmniCore)
Continued
To Next Page
Loading...
