Section 7 AC Power Input Assembly
Abbott VP 2000™ Processor Service Manual 7-43
30-608308/R1—September 2008
Installation
Reassemble the plunger on the interlock switches as the outer
panel is installed.
CAUTION: Depress the plunger on the interlock
switches as the outer panel is installed.
CAUTION: Before sliding the Top Cover back into
position, make sure all wiring, cables and connectors
are replaced snugly, within the unit and not hanging
out where they might be sheared off when replacing
the cover.
NOTE: When replacing the vertical side panel, make
sure all wires and cables are within the unit and out of
the way when the panel is slid into position.
To Next Page
Loading...
