3
12
3 - Communication
3�2�2 Direct connection using the Connection Wizard
If you use a direct connection as described in 3.3, you can use the Connection Wizard. If everything
works you will be able to browse to your WMPro directly, see 3.4. If you connect your WMPro to an
existing network instead, you should follow the instructions starting at 3.2.3.
The Connection Wizard is a small program that sets the computer IP address, searches for a con-
nected WMPro and opens a browser.
The program is available for download from the Support section of the Abelko web site www.
abelko.se. It automatically runs a "route add" command and opens a browser.
The program does not have a special install routine – simply copy it to the desktop or to its own
folder. You can even run it directly from a diskette or CD-ROM. Important: The program only works
in Windows 2000 or XP, and you must have administrator rights on your computer�
3�2�3 Connecting manually using the network
Start by nding out your own network address by opening a DOS
window and typing "arp -a" at the command prompt. To open a DOS
window, click Run on the Start menu and type "command" in Win-
dows 98 or "cmd" in Windows NT/2000/XP.
The top line of the results contains the IP
address of your network adapter. Exam-
ple:
C:\>arp -a
Interface: 192�168�2�126 on interface
0x2000003
In this case, 192.168.2.126 is your com-
puter's IP address.
To Next Page
Loading...
Need help?
General