To Next Page

To Previous Page

3 - Communication

3�12 Monitoring communication

If you are using a modem to connect a WMPro, the modem can sometimes hang. Contact with the

installation is lost, and someone has to physically go to the modem and switch it o and on again. If

Communication

The WMPro is able to restart a mo-

dem if it hangs.

you connect the power supply to the modem via a digital

output (DU8), the WMPro can restart the modem by itself

if contact is lost. You can change the settings in Settings/

Communication/Com.control.

You can restart the modem, reboot the entire system, or

both. Certain conditions must be met before each restart/

reboot.

Active restart/reboot function: Check the box to activate.

Portal update fail count limit: The number of failed portal updates before a restart/reboot. (Impor-

tant: The WMPro must be logged into the portal. It is not enough simply to be in contact.)

HTTP disconnection time limit: The number of hours since someone browsed to the device before a

restart.

Min restart/reboot interval: Minimum number of hours between two restarts.

Time window for restart/reboot: Select an hour during the 24-hour period when you want any re-

start/reboot to take place.

If you leave 0 in any eld, that condition will be ignored. Save the settings when you make any

changes. Important: The restarts/reboots are each saved separately.

Abelko IMSE WebMaster Pro User Manual

Questions and Answers: