17
123
17 - Operator panel
The last command is called Test. This sends a test SMS text message to all recipients.
Turn to 3.8 for details of the requirements for SMS alarm notications. You can use the operator
panel to enter the recipients' phone numbers.
17�4�7 Restart
You can use this menu to restart the WMPro.
17�5 Controller menus
When you use the controller tool to create a controller, the
tool also add new options to the operator panel. A menu
with the same name as the controller is placed after the
permanent menus in the menu list. The menu contains the
channels and parameters that are important for controller
operation.
The channels usually appear rst in the controller menu,
showing the current values of sensors and actuators and
the internal status of the controller.
In the case of parameters, you can not only view the values
but change them as well. To do this, press OK (and log in).
Use the arrow keys to change one digit at a time in the
usual way, then press OK again when you have nished.
Some parameters are subject to upper or lower limits. If
you attempt to save a value outside these limits, an error
message appears "ERROR: Write param!". This means that
the value has not been saved. The operator panel returns
to edit mode, where you can try again.
17�6 Curves
Starting from WMPro release 1.3, you can use the operator panel to edit curves. Curve menus are
identied by the word curve in brackets below the name.
Press OK to access the curve edit functions. The rst setting
is the Y-label, in other words what the Y-axis is called, and
the unit for the Y-axis value. If you press the down arrow
you will see the X-label. You cannot change these labels
from the operator panel.
Value Radiator ctrl.
45.3 ºC
I-time Radiator ctrl.
180.0 s
ERROR:
Write param!
Radiator ctrl.
(curve)
To Next Page
Loading...
Need help?
General