6
46
6 - Controllers
Specify the delay, the email option
and the alarm type for pump feed-
back. The delay is time between the
moment the feedback loop is inter-
rupted to the moment the alarm is
triggered. This value also species the
delay before starting the spare pump
or twin pump if they are installed.
You can add information to the alarm
email that is sent. To do this, go to
Settings/Alarms. See section 7.
You have now nished conguring the controller, and all you need to do is save it. Click Save and
wait for the controller tool to generate a script and restart WMPro – this takes about three or four
minutes. If you want to congure a new controller, you can get going as soon as the WMPro has
restarted.
After conguring all your controllers and waiting for the WMPro to restart for the last time, you will
need to update your browser.
6�1�2 Changing or removing a controller
When you open the controller conguration page, you will see a list of all existing controllers that
were congured using the controller tool. Select the controller you want to change or remove, then
click the relevant button. If you have bypassed the controller tool and congured a controller with a
script, you will have to use the script to edit or delete the controller.
You will see a new tab under the "View" menu. The tab name is the
name you assigned the controller earlier. If there is more than one
controller, each has its own tab. You can use the tabs to view con-
troller data and modify all adjustable parameters and curves.
To Next Page
Loading...
Need help?
General