Abus HDCC90001 - Linkage Action Tab; PTZ Linking Tab; Live View; General Tab

Setting: Configuration
36
 Set the time at which the responses selected on the
“Linkage Action” tab are activated when there is an
alarm.
 Click on “Copy” to apply these settings to other days
of the week or the entire week.
Linkage action tab
Select the Linkage action tab. Here. you can configure
the response of the recorder in the event of an alarm by
ticking the corresponding box. All actions can be enabled
simultaneously.
Parameter
Notifications
Full Screen Monitoring
The camera is displayed in
full screen in live view.
Audible Warning
The recorder emits a
repeated signal tone.
Notify CMS
A notification will be sent
by network command to the
CMS software.
Send email
An email is sent to a
specified email address.
Trigger alarm output
The selected alarm output
is triggered in the event of
an alarm.
PTZ linking tab
Here you can control specific PTZ presets, patrols or
patterns for a taught-in camera.
Parameter
Notifications
PTZ
Select the camera to be
controlled using a PTZ
command in the event of
an alarm.
Call preset
Select the preset number.
Start patrol
Select the patrol number.
Start pattern
Select the pattern number.
 Confirm the settings by clicking on Apply and exit
the menu by clicking on OK.
Live view
In the live view menu, define the behaviour of the local
image output on the recorder. This includes the basic
settings for the menu display and the configuration of the
cameras' image distribution in multi-view.
General tab
The following settings are available in the General tab: