Adtech ADT-DK300A - Page 107

BZ001M056A ADT‐DK300A/400A Engraving Machine

98
can be configured by modifying this parameter. The setting method is
pressingtheEOBkeyandselectingin thepop‐up dialogbox,andpress
and hold the EOB key for three seconds to exit. The black option
indicates home operation. You can press UP/DOWN key and Page
Up/Downkeyto
selectthehomeaxisandstage.

077 
ArcAcc.forRadii
078 
ArcAcc.forSpeed
Range : 10~10010~10000
Unit : Coefficient
Authority : Operationadminorhigher
Default : 50,100
Effectivetime : Instant
Note : Usedto restrictthearcprocessingspeedautomatically.Thisparameter
isvalidinpretreatmentmode.
Thebiggertheradiuscoefficientis,thelowerthearcspeedis.
Thebigger
theaccelerationcoefficientis,thehigherthearcspeedis.

079  PretreatmentCodeSet
Range : 100~1000
Unit : Instructionline
Authority : Operationadminorhigher
Default : 500
Effectivetime : Instant
Note : Set the pre‐reading instruction lines; if the pretreatment processing
pauses and pre‐reads, please increase this value to pre‐read more
instructions.

080 
InpAccSpeedMode
081 
'S'SpeedAcceleration
Range : 0~11000~10000
Unit : None
Authority : Operationadminorhigher
Default : 0,5000
Effectivetime : Instant
Note :
UsedtosettheperformanceofScurveacceleration/deceleration
The interpolation mode 0 is linear acceleration/deceleration, 1 is S