Adtech ADT-DK300A - Page 120

BZ001M056A ADT‐DK300A/400A Engraving Machine

111

050 
XEncoderbit(p)
051 
YEncoderbit(p)
052 
ZEncoderbit(p)
053 
4Encoderbit(p)
Range : 0~9999
Unit : Wirenumber
Authority : SuperAdmin
Default : 2500
Effectivetime : Instant
Note : Set the encoderwires connected toevery pulseport (AB phasepulse).
Sincefourtimesfrequencydivisionisperformedforinternaltransfer,the
value of this parameter should be the pulses
collected by the encoder
foronecycledividedby4.

058 
XPulseLogicLevel(restart)
059 
YPulseLogicLevel(restart)
060 
ZPulseLogicLevel(restart)
061 
4PulseLogicLevel(restart)
Range : 0~1
Unit : LOGICVOLTAGELEVEL
Authority : SuperAdmin
Default : 0
Effectivetime : Restart
Note : Setthenormalvoltagelevel whenthepulseisworking.Ifthesettingis
different from the normal voltage level required by motor drive, a
directionwillhaveaccumulativeerror
duringeverypositiveandnegative
motion(independentofpulses).Therefore,ifthepositioningaxisofthe
machinehasaccumulativeerrorinadirection,pleasecheckwhetherthis
parametermatches.

062 
Xfeature(Rotate0Line1)
063 
Yfeature(Rotate0Line1)
064 
Zfeature(Rotate0Line1)
065 
4feature(Rotate0Line1)
Range : 0~1
Unit : None