Adtech ADT-DK300A - Page 122

BZ001M056A ADT‐DK300A/400A Engraving Machine

113
axis and is positioning but doesn’t process, enable this function to
shortenthemotiontime.
0:Donotoptimizethepath 
1:Enabletheshortestpath
Note:Ifprocessingisrequiredduringthemotion,theshortestpathmay
benotyourdesiredprocessingtrack.
074 
MaxAccofX(Kpps)
… 
…
077 
MaxAccof4(Kpps)
Range : 100~8000
Unit : Kpps(KiloPulsePerSecond)
Authority : SuperAdmin
Default : 2000
Effectivetime : Instant
Note :
Set the maximum acceleration of every axis. This settingwillaffect the
trackspeedoptimizationofpretreatmenttoeveryaxis.Ifahighvalueis
set,the axis
response time will be shortened and characteristics of the
motorwillbeimprovedaccordingtothemachinetool.
Thisparameteralsoaffectsthehomefunctionandlimitstopfunction.
Hardlimitfunction:Usehardlimitinsoftwarescanningmode,in which
the hard limit decelerates and stops according to the maximum

accelerationofthisaxis.Therefore,ifthisvalueistoohigh,the machine
toolwillstopinemergency,andifthisvalueistoolow,itwillcausetoo
muchovershoot.
Homefunction:thehomeaccelerationofeveryaxisusesthisvalue.

078 
XServoHomeDir
079 
YServoHomeDir
080 
ZServoHomeDir
081 
4ServoHomeDir
Range : 0~1
Unit : None
Authority : SuperAdmin
Default : 0