BZ001M056A ADT‐DK300A/400A Engraving Machine
89
031
InpAcceleration(mm/sec)
039
XBacklashExpiate(pulse)
Range : 1~200000,1~200000,1~8000,1~200000
Unit : mm/min,mm/min,mm/sec,mm/min
Authority : Operationadminorhigher
Default : 3000,200,1000,3000
Effectivetime : Instant
Note : ThefeedinginstructionssuchasG01,G02andG03moveatthespeedof
F instruction. If the F instruction isn’t specified in the program, the
above instructions move at
the speed set by this parameter. If the F
instructionisspecified,thisparameterwillbeinvalid.
The maximum feeding speed restricts the F instruction during
processing,i.e. no matter what F is set, the actual speed can’t exceed
this parameter value. Setting this parameter will prevent the damage
caused by accidental speed programming error when transferring
processingfiles.
032
XBacklashExpiate(pulse)
033
YBacklashExpiate(pulse)
034
ZBacklashExpiate(pulse)
035
4BacklashExpiate(pulse)
Range : 1~20000
Unit : Pulse
Authority : Operationadminorhigher
Default : 0
Effectivetime : Instant
Note :
1.Compensatetheclearancebetweencontrolaxis
2. Compensate with the pulse in minimum unit. The specific number
shouldbeconvertedaccordingto gear ratio. Forexample,thebacklash
measured
bythemachinetoolis0.1mmandthegearratioofthesystem
isCMR/CMD=1/1,thecompensationpulsesisp=0.1*1000*1/1=100.
036 ZeroReturnMode
Range : 0~1
Unit : None
Authority : Operationadminorhigher
Default : 0(program)
Effectivetime : Instant
To Next Page
Loading...
