MANAGING SWITCH
115
The ensuing table for User Status settings are informational only: User Name, Access
Right, Auth-Protocol, Priv-Protocol and Delete (click to delete the desired user name).
SNMP Trap
The SNMP Trap page allows you to set the IP address of the node and the SNMP
credentials corresponding to the version that is included in the trap message.
To access this page, click Management > SNMP > SNMP Trap.
Figure 4-88. Management > SNMP > SNMP Trap
The following table describes the items in the previous figure.
The ensuing table for Trap Host Status settings are informational only: No., IP Address,
Community Name, Version and Delete (click to delete the desired IP address).
Password Enter the characters to define the password associated with the
authorization protocol.
Add Click Add to save the values and update the screen.
Table 4-86. Management > SNMP > SNMP Trap
Item Description
IP Address Enter the IP address to designate the SNMP trap host.
Community Name Click the drop-down menu to select a defined community name.
Version Click the drop-down menu to designate the SNMP version credentials (v1
or v2c).
Add Click Add to save the values and update the screen.
Table 4-85. Management > SNMP > SNMP User Settings (Continued)
Item Description
To Next Page
Loading...
Need help?
General
