Advantech EKI-7428G Series - Local Logging

MANAGING SWITCH
136
The following table describes the items in the previous figure.
The ensuing table for Logging Information settings are informational only: Logging
Service.
Local Logging
The Local Logging page allows you to designate a local target when the severity criteria is
reached.
To access this page, click Diagnostics > System Log > Local Logging.
Figure 4-108. Diagnostics > System Log > Local Logging
The following table describes the items in the previous figure.
Table 4-105. Diagnostics > System Log > Logging Service
Item Description
Logging Service Click Enabled or Disabled to set the Logging Service status.
Apply Click Apply to save the values and update the screen.
Table 4-106. Diagnostics > System Log > Local Logging
Item Description
Target Enter the local logging target.
Severity Click the drop-down menu to select the severity level for local log
messages.
The level options are:
 emerg: Indicates system is unusable. It is the highest level of severity
 alert: Indicates action must be taken immediately
 crit: Indicates critical conditions
 error: Indicates error conditions
 warning: Indicates warning conditions
 notice: Indicates normal but significant conditions
 info: Indicates informational messages
 debug: Indicates debug-level messages
Apply Click Apply to save the values and update the screen.