MANAGING SWITCH
134
4.10.3 IPv6 Ping Test
The IPv6 Ping Test page allows you to configure the Ping Test for IPv6.
To access this page, click Diagnostics > IPv6 Ping Test.
Figure 4-106. Diagnostics > IPv6 Ping Test
The following table describes the items in the previous figure.
Table 4-104. Diagnostics > IPv6 Ping Test
Item Description
IPv6 Address Enter the IP address or host name of the station you want the switch to
ping. The initial value is blank. The IP Address or host name you enter is
not retained across a power cycle. Host names are composed of series of
labels concatenated with dots. Each label must be between 1 and 63
characters long, and the entire hostname has a maximum of 64 characters.
Count Enter the number of echo requests you want to send. The default value is
4. The value ranges from 1 to 5. The count you enter is not retained across
a power cycle.
Interval (in sec) Enter the interval between ping packets in seconds. The default value is 1.
The value ranges from 1 to 5. The interval you enter is not retained across
a power cycle.
To Next Page
Loading...
Need help?
General
