MANAGING SWITCH
137
The ensuing table for Local Logging Settings Status settings are informational only:
Status, Target, Severity and Delete (click to delete the desired target).
System Log Server
The System Log Server page allows you to configure the log server.
To access this page, click Diagnostics > System Log > System Log Server.
Figure 4-109. Diagnostics > System Log > System Log Server
The following table describes the items in the previous figure.
The ensuing table for Remote Logging Setting Status settings are informational only:
Status, Server Info, Severity, Facility and Delete (click to delete the desired server address).
Table 4-107. Diagnostics > System Log > System Log Server
Item Description
Server Address Enter the IP address of the log server.
Server Port Enter the Udp port number of the log server.
Severity Click the drop-down menu to select the severity level for local log
messages. The default is emerg.
The level options are:
emerg: Indicates system is unusable. It is the highest level of severity
alert: Indicates action must be taken immediately
crit: Indicates critical conditions
error: Indicates error conditions
warning: Indicates warning conditions
notice: Indicates normal but significant conditions
info: Indicates informational messages
debug: Indicates debug-level messages
Facility Click the drop-down menu to select facility to which the message refers.
Apply Click Apply to save the values and update the screen.
To Next Page
Loading...