MANAGING SWITCH
42
The following table describes the items in the previous figure.
The ensuing table for System Time Information settings are informational only: Current
Date/Time, SNTP, SNTP Server Address, SNTP Server Port, Time zone, Daylight Saving
Time, Daylight Saving Time Offset, From and To.
Table 4-12. System > System Time
Item Description
Enable SNTP Click the radio button to enable or disable the SNTP.
SNTP/NTP Server
Address
Enter the address of the SNTP server. This is a text string of up to 64
characters containing the encoded unicast IP address or hostname of a
SNTP server. Unicast SNTP requests will be sent to this address. If this
address is a DNS hostname, then that hostname should be resolved into
an IP address each time a SNTP request is sent to it.
SNTP Port Enter the port on the server to which SNTP requests are to be sent.
Allowed range is 1 to 65535 (default: 123).
Manual Time Click the drop-down menus to set local date and time of the system.
Time Zone Click the drop-down menu to select a system time zone.
Daylight Saving Time Click the drop-down menu to enable or disable the daylight saving time
settings.
Daylight Saving Time
Offset
Enter the offsetting variable in seconds to adjust for daylight saving time.
Recurring From Click the drop-down menu to designate the start date and time for daylight
saving time.
Recurring To Click the drop-down menu to designate the end date and time for daylight
saving time.
Non-Recurring From Click the drop-down menu to designate a start date and time for a non-
recurring daylight saving time event.
Non-Recurring To Click the drop-down menu to designate the end date and time for a non-
recurring daylight saving time event.
Apply Click Apply to save the values and update the screen.
To Next Page
Loading...
Need help?
General
