R3131 Spectrum Analyzer Operation Manual
2.4 Other Functions
2-98 Aug 28/98
Figure 2-94 Printer Setup Screen
6. Press Print CMD PCL/ESCP/ESCP-R.
This toggles the printer control code between PCL, ESCP and ESCP-R. The
spectrum analyzer can use either ESCP (Epson Standard Cord for Printer),
ESCP-R (Epson Standard Cord for Printer Raster mode) or HP PCL (Hewlett
Packard Printer Command Language). Select as appropriate.
7. Press Copy Mode GRAY/B/W.
Toggles the copy mode between gray scale (four levels) and Black & White.
Select as desired.
8. Press Copy Size HALF/FULL.
Selects the size used for the printed copy. HALF is approximately the same size
as the screen display while FULL prints the screen horizontally on A4 paper.
Select as desired.
9. Press RETURN.
Returns to the Config(1) menu.
Printing
10. Display the screen you wish to print out, and then press COPY.
The screen data is sent to the printer. The time required for the data to print out
depends on the mode and printer used.
NOTE: Press SHIFT, COPY and Abort to abort printing after Copy has been
pressed.
To Next Page
Loading...
Need help?
General
