ADVANTEST R3131 User Manual

R3131 Spectrum Analyzer Operation Manual
3.3 Menu Function Descriptions
3-26
3.3.8 EMC Key (EMC Measurement)
This section describes the menu displayed when the SHIFT key and the 1(EMC) key are pressed.
Detector Mode Displays the Detector menu.
QP Displays the QP BW menu and detects the quasi peak value.
RBW Auto Automatically sets the resolution bandwidth.
RBW 9kHz Sets the resolution bandwidth to 9 kHz.
RBW 120kHz Sets the resolution bandwidth to 120 kHz.
Peak Displays the Peak BW menu and detects the peak value.
RBW Auto Automatically sets the resolution bandwidth.
RBW 9kHz Sets the resolution bandwidth to 9 kHz.
RBW 120kHz Sets the resolution bandwidth to 120 kHz.
Normal Switches to the current detector as set at Detector (the Trc Det
menu) in the TRACE.
Field Displays the Antenna menu. From here, select the antenna factor
you wish to correct for (5D2W cable, 10 m including the cable
loss).
TR1722 Corrects for half-wave dipole antennas (TR1722).
UHALP9107 Corrects for log-periodic antennas (UHALP9107).
BBA9106 Corrects for biconical antennas (BBA9106).
EMCO3142 Corrects for bilog antennas (EMCO3142).
User Ant Corr Opens the user-definable correction table, and displays the
correction data list in the User Ant Corr menu.
Next Page Displays the next page of the correction data list.
Prev Page Displays the previous page of the correction data list.
Corr Mode ANT/LVL
Toggles between the antenna factor (for the defined correction
Apr 10/98

ADVANTEST R3131 Specifications

General

Brand	ADVANTEST
Model	R3131
Category	Measuring Instruments
Language	English