R3131 Spectrum Analyzer Operation Manual
3.3 Menu Function Descriptions
3-42
3.3.18 POWER MEASURE Key (Power Measurement)
This section describes the menu displayed when the POWER MEASURE key is pressed.
Channel Power Displays the CH Power menu.
CH Power ON/OFF Allows you to measure the total power in a specified channel
bandwidth.
ON: Measures the total power in a channel bandwidth
specified by the measuring window. Allows you to set
the averaging count.
OFF: Turns off total power measurement.
CH BW POS/WD Allows you to set the position and width of the measuring window
(channel bandwidth).
POS: Allows you to set the center position of the measuring
window (channel bandwidth).
WD: Allows you to set the width of the measuring window
(channel bandwidth).
CH BW SRT/STP Allows you to set the start and stop frequencies for the measuring
window (channel bandwidth).
SRT: Start frequency for the measuring window (channel
bandwidth).
STP: Stop frequency for the measuring window (channel
bandwidth).
Total Power Measures the total power in the object range (the entire
measurement span or window). Allows you to set the averaging
count.
Average Power Measures the power averaged over the object range (the entire
measurement span or window). Allows you to set the averaging
count.
Carrier Power Moves the marker to the peak point on the trace, and measures the
carrier power.
Pwr Meas Off Turns off the power measurement function.
OBW Displays the OBW menu.
Jul 10/98
To Next Page
Loading...
Need help?
General
