Aeroflex 3412 - Page 302

REMOTE OPERATION FM COMMANDS
4-92
[SOURce][:MODulation]:FM2:INTernal:PHASe
Description: Sets the phase offset of FM2 relative to FM1.
Parameters: <numeric_value>
Valid values: <NRf> | UP | DOWN
*RST sets: 0
[SOURce][:MODulation]:FM2:INTernal:PHASe?
Description: Queries the phase offset of FM2 relative to FM1.
Parameters: None
Response: <NR2>
Returned values: Phase angle (degrees)
[SOURce][:MODulation]:FM2:INTernal:PHASe:SENSitivity
Description: Selects the sensitivity of the rotary control or
x10
and
10

keys when setting up the
phase offset of FM2 relative to FM1.
Parameters: <CPD>
Valid values: FINe (0.01º resolution)
MEDium (0.1º resolution)
COARse (1.0º resolution)
*RST sets: FINe
[SOURce][:MODulation]:FM2:INTernal:PHASe:SENSitivity?
Description: Queries the sensitivity of the rotary control or
x10
and
10

keys when setting up the
phase offset of FM2 relative to FM1.
Parameters: None
Response: <CRD>
Returned values: FIN | MED | COAR