Aeroflex 3412 - Page 367

REMOTE OPERATION SWEEP COMMANDS
4-159
[SOURce]:SWEep:TRIGger[:MODe]
Description: Sets the trigger mode to off, start, start then stop, or step.
Parameters: <CPD>
Valid values: OFF | STARt | SSTOP | STEP
*RST sets: OFF
[SOURce]:SWEep:TRIGger[:MODe]?
Description: Queries the trigger mode for the sweep.
Parameters: None
Response: <CRD>
Returned values: OFF | STAR | SSTOP | STEP
[SOURce]:SWEep:TRIGger:SLOPe
Description: Sets the polarity of the sweep trigger.
Parameters: <CPD>
Valid values: POSitive | NEGative
*RST sets: POS
[SOURce]:SWEep:TRIGger:SLOPe?
Description: Queries the polarity of the sweep trigger.
Parameters: None
Response: <CRD>
Returned values: POS | NEG