© Agilent Technologies 1989–2002 Agilent 3070 / 79000 Site Preparation 9-16
Chapter 9: Site Preparation – Receiving and Moving Instructions: Re-shipping a 3070 and 79000 System
Re-shipping a 3070
and 79000 System
When it becomes necessary to pack and ship a 3070 /
79000 system to another location, Agilent can help.
You can either purchase an Agilent Move, which
includes Agilent personnel disassembling, packing,
shipping, and setting up the system at the new location;
or you can purchase a shipping kit from Agilent, which
includes the pallet and other materials required to ship a
3070 system.
As when a system is installed, when a system is moved,
the procedures should be performed by an
Agilent-trained technician. The Shipment Kit part
numbers are listed in
Table 9-2 and Table 9-3.
Other Shipment Kits were being designed at the time of
this printing. To order or inquire about a Shipment Kit
in the U.S. contact Agilent’s Measurement System
Knowledge Center (MSKC). In the U.S. call
1-800-593-6635 with your MSKC support handle.
Outside the U.S. call your local Agilent Service
Representative to access the MSKC.
WARNING
✸
When re-shipping a support or instrument bay,
DO NOT use the ramp to move the bay onto the
pallet to avoid possible injury due to the bay
tipping over on you. The ramp is designed for
removal of the bay only. Instead, use a hoist and
attach to the hooks on the top of the bay and lift
the bay onto the pallet.
Table 9-2 Shipment kit special option product numbers
Testhead Support Bay POTS Bay Controller
Series I 307X, 317X 44813A Opt. 555
(Testhead and
Support Bay Pallet)
n/a 44813A Opt. 551
(19-in. Bay)
Series II 307X, 317X 44813A Opt. 565 44813A Opt. 567 44813A Opt. 567 n/a
Series II 327X 44813A Opt. 566 n/a 44813A Opt. 567 n/a
Series 3 307X, 317X,
3070 (Win), 79000
1
44813A Opt. 570 44813A Opt. 572 44813A Opt. 572 n/a
Series 3 327X, 327X (Win) 44813A Opt. 571 n/a 44813A Opt. 572 n/a
1. 3070 MS Windows system must use a pallet received after March 2000.
To Next Page
Loading...
Need help?
General
