Agilent Technologies 3070 Series - Agilent 3070 Series II Networking

© Agilent Technologies 1989–2002 Agilent 3070 / 79000 Site Preparation 8-5
Chapter 8: Site Preparation – Communications Cabling Requirements: Local Area Network Requirements
Agilent 3070 Series II Networking
Networking is very versatile with the 3070 Series II
system. Before installing the Series II system, fill in the
table below with the system name and IP address of the
testhead controller and every other new controller in
your Series II network.
An example of the 3070 Series II internal testhead and
external LAN connections is shown in
Figure 8-2 on
page 8-6. The optional LAN/Gateway is only used if a
HP 9000 712/60/100 controller is used. All other Series
700 controllers have an GPIB card installed in the
controller.
Install the LAN Cabling
Before the 3070 / 79000 family system is delivered,
install and test the external LAN interface cabling.
System Name IP Address
Testhead
Controller
Other Controller
#1
Other Controller
#2