© Agilent Technologies 1989–2002 Agilent 3070 / 79000 Site Preparation 9-12
Chapter 9: Site Preparation – Receiving and Moving Instructions: Uncrating The System
Uncrating the Support Bay
WARNING
✸
The Support Bay weighs approximately 209
kilograms (460 pounds). To avoid personal injury,
follow these instructions carefully and do not
work alone. The shipping straps are stretched taut
and will whip when cut. Wear eye protection
when cutting straps.
In uncrating the Support Bay, you will roll the Support
Bay down a ramp from the pallet. To do this you will
need an area approximately 6 feet (2 meters) wide by 13
feet (4 meters) long.
Tools Needed to Uncrate the Support Bay:
â– Utility knife
â– 7/16-inch socket with ratchet
â– 9/16-inch socket with ratchet
Uncrating Procedure:
1 Remove the ramp and packing material from the top
of the Support Bay and remove the packing material
from around the outside of the Support Bay.
2 Figure 9-6: Remove the two shippin clamps (one on
each side) from the bottom of the Support Bay (1, 2).
To Next Page
Loading...
Need help?
General
