© Agilent Technologies 1989–2002 Agilent 3070 / 79000 Site Preparation 10-79
Chapter 10: Site Preparation – Power Requirements for Older Systems: Series 3 Power Requirements and Connections (Prior to May 2000)
Table 10-5 Serial numbers of Series 3 / 79000 systems with factory power reconfiguration reduction
1
(but without power cords
attached except 327X and 79000 power option AWW)
System Type 79000 327X 317X 307X
Testhead Product E2190A E9997A E9998A E9900A
Serial Number
between
US38050137 and
US38050120
US38240247 and
US38240152
US38240409 and
US38240243
US38240532 and
US38240240
1. DUTS and Controllers set to 220-240 volt operation and load balanced
Table 10-6 Serial numbers of Series 3 / 79000 systems shipped without power reconfiguration reduction
1
(see Chapter 11, Site
Preparation – Series 3 / 79000 Current Reduction Conversion for how to reduce current requirements)
System Type 79000 327X 317X 307X
Testhead Product E2190A E9997A E9998A E9900A
Serial Numbers
between
US38050119 and
US38050109
US38240151 and
US38240115
US38240242 and
US38240139
US38240239 and
US33240114
1. i.e., DUTS and Controllers are set to 100-120 volts.
Table 10-7 Serial numbers of Series 3 / 79000 systems shipped with E1135B PDUs.
System Type 79000 327X 317X 307X
Testhead Product E2190A E9997A E9998A E9900A
Serial Numbers
between
US38050108 and
US38050100
US38240114 and
US38240100
US38240138 and
US38240100
US38240113 and
US33240100
To Next Page
Loading...
