42 Chapter 2 Getting Started
Operating from Remote
This section shows you the fundamentals of operating the multimeter from
remote. This includes reading and changing the GPIB address, sending a
command to the multimeter, and retrieving data from the multimeter.
Input/Output
Statements
The statements used to operate the multimeter from remote depend on the
computer and its language. In particular, you need to know the statements
the computer uses to input and output information. For example, the input
statements for the Hewlett-Packard Series 200/300 BASIC language are:
ENTER or TRANSFER
The output statement is:
OUTPUT
Read your computer manuals to find out which statements you need to use.
The examples in this manual use Hewlett-Packard Series 200/300 BASIC
language.
Reading the GPIB
Address
Before you can operate the multimeter from remote, you need to know its
GPIB address (factory setting = 22). To check the address, press:
Figure 10. Installing the keyboard overlay
Local
Address
To Next Page
Loading...
Need help?
General
