Agilent 1290 Infinity Binary Pump User Manual 235
LAN Configuration
13
Dynamic Host Configuration Protocol (DHCP)
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. Agilent ChemStation, LabAdvisor,
Firmware Update Tool) and use MAC address as host name, e.g.
0030d3177321.
The LC system should become visible in the control software (see Note in
section “General Information (DHCP)” on page 232).
Tab le 19 LC Modules inclusive 1120/1220 (configuration switch at rear of the instru-
ment)
SW 6 SW 7 SW 8 Initialization Mode
ON OFF OFF DHCP
To Next Page
Loading...
