Allen-Bradley PanelView Plus 7 User Manual

50 Rockwell Automation Publication 2711P-UM007D-EN-P - December 2015
Chapter 3 Configure Terminal Settings
Reset the Desktop Password
To clear and change the current password, you must correctly respond to the
current challenge question. If you do not remember the response, you must
restore the terminal to its factory defaults. Refer to Maintenance Mode
Operations on page 143.
Follow these steps to reset the desktop password.
1. Press Reset Password from the Desktop Access Management dialog box.
2. Press Answer Challenge and enter the correct response to the current
challenge question.
3. Press Clear Password to clear the current password and challenge
question.
The dialog box shows the updated status of the password and challenge
information.
4. Press Close.
5. Refer to Set a Desktop Password
on page 49 to set a new password and
challenge question.
After clearing the password, you must set a new desktop password or
change the desktop access to ‘Allow’.
IMPORTANT You can reset the password and challenge questions if access to the desktop
is restricted or set to disallow.

Allen-Bradley PanelView Plus 7 Specifications

General

Operating System	Windows CE 6.0
Memory	512 MB RAM
Mounting	Panel mount
Display Type	Color TFT LCD
Processor	ARM Cortex-A8
Storage	512 MB Flash
Communication Ports	Ethernet, USB, Serial
Input Voltage	24V DC
Operating Temperature	0°C to 50°C (32°F to 122°F)
Environmental Rating	NEMA 4X
Storage Temperature	-20°C to 60°C (-4°F to 140°F)
Relative Humidity	5% to 95% non-condensing
Certifications	CE, UL, cUL
Display Sizes	4.3", 7", 10", 15", 19"
Touchscreen	Resistive or Projected Capacitive (depending on model)