Allen-Bradley Series B - Page 7

Table of Contents
v
Chapter 6
Check Character Verification 6-8
Interleaved 2 of 5 Length Checking 6-8
Minimum and Maximum Lengths 6-9
Code 128 6-9
Code 11 6-10
Minimum and Maximum Lengths 6-10
Selecting the Number of Code 11 Check Characters 6-10
Enable UPC/EAN 6-11
Read UPC Versus UPC/EAN 6-11
Expand UPC 6-11
Supplemental Digits (UPC/EAN) 6-12
Autodiscriminate Supplements (UPC/EAN) 6-12
Codabar 6-13
Start/Stop Character Transmission (Codabar) 6-13
Minimum and Maximum Lengths (Codabar) 6-13
Code ID Character Transmission 6-14
Check Character Transmission 6-14
Code ID Character Assignment 6-15
Baud Rate Selection 6-16
Parity 6-17
Stop Bits 6-17
RTS/CTS Handshaking 6-18
Intercharacter Delay 6-18
Fixed Serial Port Configuration at Reset 6-18
XON/XOFF Pacing 6-19
Single Read Mode 6-19
Display Terminal Port 6-19
Header 6-20
Trailer 6-20
Reader Address 6-20
No-Read Recognition 6-20
Serial Number 6-20
LED Beeper Control 6-21
Good Read Beep 6-21
Speaker Volume 6-21
Laser Redundancy Check 6-22
Laser Connection Detection 6-22
Continuous Read Mode 6-22
Laser Shutoff Delay 6-23
Trigger Latch Mode 6-23
Programming Via
Configuration Bar Code
Symbols